Filter
Top Products
Operating Instructions
25
The washing cycle is finished/Remove the washing
After a washing program has ended, the indicator END lights up on the
program sequence display.
• If the program EASY IRON was chosen, an anti-creasing phase of ap-
prox. 30 minutes follows after the program ends. The Multi-display
shows a remaining time and the indicator END lights up. During the
anti-crease phase you can open the filling door at any time and re-
move the washing.
• If RINSE HOLD was selected, the indicator next to the button START/
PAUSE flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the button START/PAUSE (water is pumped off and the
washing is spun according to the completed program; With the but-
ton Spin speed/RINSE HOLD it is possible to also change the spin
speed during spinning),
or
– Turn the program selector to PUMP OUT and press the START/PAUSE
button (the water is pumped off without spinning),
or
– Turn the program selector to SPIN or SHORT SPIN and press the
button START/PAUSE (water is pumped off and the washing is spun
or gently spun).
The indicator END lights up at the end of this program step.
2. Open the filling door. As soon as the indicator DOOR lights up green,
the filling door can be opened.
3. Remove the washing.
4. Turn the program selector to OFF.
5. Close the water tap.
6. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If the display OVER DOSING lights up, too much
washing detergent was used in the washing program
just ended. During the next wash, pay attention to
the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.