Filter
Top Products
19
E10 appears.
The END indicator is
flashing once, and si-
multaneously an acous-
tic signal is sounding
once.
(Problems with the wa-
ter inflow.)
The tap is shut off. Turn on the tap.
The filter in the inlet hose
screw connection is blocked.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
The tap is blocked by limes-
cale or faulty.
Check the tap and have it re-
paired, if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed.
Remove the transit packag-
ing.
The screw feet have not
been correctly adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
There is very little washing
in the drum (e.g. just one
bathrobe).
Operation is not affected by
this.
Water is running out
from under the washing
machine.
The inlet hose screw con-
nection is leaking.
Tighten the inlet hose.
The outlet hose is leaking. Replace outlet hose.
The drain pump lid has not
been closed properly.
Close the cover properly.
Washing was caught in the
door.
Load carefully next time you
wash.
The emergency drain hose is
leaking.
Screw on the emergency
drain hose firmly.
The wash water is
foaming a lot. At the
end of the wash cycle
the spinning stops.
Probably too much deter-
gent has been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
E20 appears.
The END indicator is
flashing twice, and si-
multaneously an acous-
tic signal is sounding
twice.
(Problems with the wa-
ter outflow.)
There is a kink in the outlet
hose.
Straighten the hose.
The maximum pump height
of 1m has been exceeded.
Please contact your local
Service Force Centre
The drain pipe is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
The spigot is blocked.
Clean the spigot.
Problem Possible cause Remedy