Filter
Top Products
18
What to do if...
Remedying small faults yourself
If during use of the appliance one of the following error codes is shown
in the multi-display:
– E10 (Problems with the water inflow),
– E20 (Problems with the water outflow),
– E40 (door open),
please consult the following table.
After the error has been remedied, press the START/PAUSE button.
In the event of other errors (E and a number or letter): Switch the ap-
pliance off and then on again. Set the programme again. Press the
START/PAUSE button.
If the error appears again, please contact your local Service Force Cen-
tre, stating the error code.
Problem Possible cause Remedy
Washing machine does
not work.
Power plug not plugged in
or problem with the fuse.
Connect the plug to a mains
socket. Check the fuse.
The door is not shut proper-
ly.
Close the door until the lock
audibly clicks into place.
The START/PAUSE button
was not pressed for long
enough.
Press the START/PAUSE but-
ton for a longer period of
time.
The door cannot be
closed.
The child safety device is ac-
tivated.
Deactivate the child safety
device:
When you press a but-
ton Err appears in the
multi-display.
The selected function can-
not be used together with
the wash programme set.
Select another function.
E40 appears.
The END indicator is
flashing 4 times, and si-
multaneously an acous-
tic signal is sounding 4
times.
The door is not closed prop-
erly.
Close the door properly. Re-
start the programme.