Filter
Top Products
32
4.Connect the hose to a tap with a
3/4” thread.
Always use the hose supplied with
the appliance.
Installation should comply with local
water authority and building regula-
tions’ requirements.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe op-
eration of the appliance.
If you cannot make the cold water
connection direct from the rising mains, you may be able to operate
the appliance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the
appliance’s inlet and the bottom of the water storage tank.
Aqua Control
The inlet hose is provided with a wa-
ter stop device, which protects
against damage caused by water
leaks in the hose which could devel-
op due to natural ageing of the
hose. This fault is shown by a red
sector in the window „A”. Should this
occur, turn the water tap off and re-
fer to your Service Centre to replace
the hose.