Filter
Top Products
16
Interrupting a programme/Adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
button (START/PAUSE) and then re-started by pressing the
button (START/PAUSE) again.
• To stop the washing machine before the programme has ended, turn
the programme knob to (OFF). Important: Be careful if there is
water in the appliance!
Adding washing
It is possible to add washing, as long as the (DOOR) light is lit green.
1.Press the
button (START/PAUSE). The door can be opened.
2.Close the door and press the
button (START/PAUSE) again. The
programme will continue.
End of the wash cycle/Removing the washing
When the programme has finished, (END) will illuminate on the pro-
gramme progress display. The door can be opened as soon as the in-
dicator (DOOR) is lit green.
1.Open the door and remove the washing.
2.Turn the programme knob to (OFF).
3.Close the water tap.
4.When you have finished washing, pull out the detergent drawer a little
to let it to dry out. Keep the door very slightly open so that the washing
machine can air.
If
(RINSE HOLD) has been selected:
Following a rinse hold (END) will be lit on the programme progress
display.
The water must first be drained off:
– Either turn the programme knob to (OFF), then to (DRAIN) and
press the button (START/PAUSE) (the water will be drained
without spinning),
– turn the programme knob to (OFF) and then to (SPIN). Change
the spin speed, if necessary, and press the button (START/
PAUSE) (the water will be drained and the washing spun).