Filter
Top Products
15
3 If the display is showing 23h and you press the button again, the time
delay will be cancelled. 0'will appear followed by the length of the
wash programme that has been set.
3.To activate the delay timer, press the
button (START/PAUSE). The
time remaining to the start of the programme is continuously displayed
(e. g., 12h, 11h, 10h,... 30
' etc.).
Starting a programme
1.Check that the tap is turned on.
2.Press the
button (START/PAUSE). The programme is started or it
starts after the time delay set has elapsed.
3 If after pressing the button (START/PAUSE) E40 flashes in the
multi-display, the (END) indicator flashes 4x and at the same time an
acoustic signal sounds 4x, the door has not been correctly shut. Push
the door firmly closed and press the
button (START/PAUSE) again.
Programme progress
• The programme progress display shows the programme step that is
currently being carried out.
– (Prewash)
– (Main wash)
– (Rinse)
– (Extra Rinse)
– (Spin)
– (End)
• The multi-display shows the estimated time remaining (in hours and
minutes) until the end of the programme.
3 The remaining programme time may increase or briefly remain constant
during the wash programme as the programme adjusts to various con-
ditions while washing (e. g. type of washing, amount of washing, rec-
ognising out-of-balance when spinning, special rinse cycle, etc.).