Filter
Top Products
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Automatic process; this is not a
machine fault.
Programme inactive, empty
water tank warning led is light-
ing.
Condensate tank is full.
Empty condensate tank, then
start programme with START
PAUSE button.
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. EXTRA
DRY instead of STORAGE DRY).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ”).
Lint filter clogged. Clean lint filter.
Fluff filter clogged. Clean fluff filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room temper-
ature. Temporary switching off
of the compressor to avoid
overload.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to “Description of machine” section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
What to do if ...
21