Filter
Top Products
Starting the programme
Press the START PAUSE button. Led above stops
flashing, becomes steady. The programme is star-
ted. Display shows elapsing cycle time or delay
time if activated.
Changing programme
To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
The programme can no longer be changed directly once the programme has started. If
nevertheless there is an attempt to change the programme on the programme knob, the
programme progress display and the maintenance indicators flash. If an option button
(excluding the BUZZER button) is pressed, Err appears in the multidisplay. The drying pro-
gramme is not however affected by this (laundry protection).
Putting in extra items or taking items out before end of programme
1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START PAUSE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, display shows a blinking "0". If the BUZZER button has
been pressed, an acoustic signal sounds intermittently for about one minute.
The drying cycles are automatically followed by an anti-crease phase which lasts around
30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose
and free of creases. The laundry can be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of the anti-crease phase at the latest to
prevent creases from forming.) If LONG ANTI-CREASE function has been selected, the anti-
crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use
a damp hand for this purpose. (See “Care and cleaning” chapter.)
3. Remove laundry.
4.
Turn the programme selector to OFF.
After each drying cycle:
14
Daily use