Filter
Top Products
User information
34
The machine is vibrating or
noisy :
• not all the packing was removed from
the machine (see unpacking section),
• the washing machine is not leveled
and properly packed,
• the washing machine is too close to
the wall or furniture,
• the washing is not well distributed in
the drum,
• the load is not sufficient.
The washing cycle is much
too long :
• the water inlet is blocked (No inco-
ming water. Check tape & hose)
• there was a power supply failure or the
water was cut off,
• the motor temperature safety device
tripped,
• the water inlet temperature is lower
than normal,
• the foam detection safety system trip-
ped (too much detergent) and the
washing machine evacuated the foam,
• the anti-unbalance mass safety device
tripped, an additional phase was
added to distribute the washing in the
drum better.
The washing machine stops
during a washing cycle :
• the water or electricity supply is
defective,
• a rinse hold was programmed.
The cover does not open
during the cycle :
• the «IMMEDIATE OPENING»
*
light is off,
• the temperature of the washing water
is too high,
• the cover cannot open until 1 to 2
minutes after the washing machine
has stopped*.
Symptom Cause