Filter
Top Products
75
Water inlet
The inlets on the back of the appliance are
colour coded, blue for cold and red for
hot.
Before connecting the hoses, be sure to fit
the filters “A” supplied as per diagram.
If only a cold water supply is available,
connect the two hoses to a cold water
outlet by means of a ‘Y’ connection piece.
The other end of the inlet hose(s) which
connects to the machine can be turned in
any direction. Simply loosen the fitting,
rotate the hose and retighten the fitting,
making sure there are no water leaks.
The inlet hose(s) must not be lengthened. If
it is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be positioned
in three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch must be above the trap so that
the bend is at least 60 cm above the ground.
Installation
P0003
A
35.292.805…Lavamat 3085 UK doc. 10/03/2003 12:22 Página 75