ADC AD-360X2 Clothes Dryer User Manual


 
25
F. FRONT PANEL AND MAIN DOOR ASSEMBLIES
TO REPLACE MAIN DOOR SWITCH
1. Discontinue power to the dryer.
2. Open main door.
3. Remove the two (2) Phillips head screws holding the main door
switch in place.
4. Disassemble door switch bracket by removing the two (2) nuts
holding the door switch to the housing, and remove the door switch.
5. Reverse this procedure for installing new door switch.
IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled.
TO REPLACE MAIN DOOR HINGE BLOCKS
1. Discontinue power to the dryer.
2. Remove the two (2) top 3/16” Allen screws securing the top hinge pin to the front panel.
3. Remove the door from the dryer by lifting the door off the bottom hinge pin.
4. Remove the bottom hinge pin assembly from the front panel, two (2) 3/16” Allen screws securing the hinge
pin to the front panel.
NOTE: Be careful not to lose the plastic washer on the hinge pin.
5. Reassemble by reversing steps.
TO INSTALL NEW MAIN DOOR GLASS
1. Remove main door assembly from the dryer (follow main door hinge removal procedure).
2. Place the main door on a flat surface with front of door face down.
3. Remove glass and clean
ALL old sealant off main door. This area must be completely cleaned for correct
bonding.
4. Apply a narrow bead of silicone (ADC PN: 170730)
ALL around main door area where glass will rest.
5. Install glass on to door and adhesive and slightly press glass in place.
IMPORTANT: DO NOT press hard or silicone thickness between the glass and door will be
reduced resulting in poor bonding.
6. The door assembly should now be put in an area where it will not be disturbed for at least 24-hours.
Depending on the conditions, the curing time of the adhesive is 24- to 36-hours.
7. After 24-hour curing period, install main door on dryer by reversing Step #1.