17
English
7. Operation
■ STARTING ENGINE
The cutting head will start rotating
upon the engine starts.
1. Feed fuel and chain oil into their
respective tanks and tighten the
caps securely. (OP1)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place.
Keep the cutting head off the
ground and clear of surrounding
objects as it will start rotating upon
starting of the engine.
3. Push the pump several times until
overflown fuel flows out in the
clear tube. (OP2)
4. Move the choke lever to the closed
position. (OP3)
(1) Choke lever
(2) Close
(3) Open
5. Set the stop switch to the "RUN"
position.
Place the unit on a flat place.
Keep the cutting head clear of
everything around it. (OP4)
(1) Stop switch
6. While holding the unit firmly, pull
out the starter rope quickly until
engine fires. (OP5)
• Avoid pulling the rope to its end or
returning it by releasing the knob.
Such actions can cause starter
failures.
7. Move the choke lever downward to
open the choke. And restart the
engine. (OP3)
8. Allow the engine to warm up for a
several minutes before starting
operation.
