Page 10 of 36
3. Rotate the yellow gas shut-off knob to the OFF position.
Figure 6: Gas Shut-Off Valve Knob
4. Open the kick panel to gain access to the screw securing the control panel.
5. Loosen the setscrew from the yellow gas shut-off knob and remove the knob.
6. Loosen the setscrew from the temperature control knob and remove the knob.
7. Remove the oven knob ring.
8. Remove the two (2) screws from the temperature control mount bracket located in the
front of the control panel.
9. Remove the screw securing the control panel.
10. Raise the lower end of the control panel to gain access to the fan control switch tabs.
11. Remove the fan control switch by compressing the tabs and pulling the switch out of the
front of the control panel.
12. Tag and disconnect the fan control switch electrical connectors.
13. Remove the control panel by lifting the bottom up and removing it from the tab located at
the top of the control panel.
14. Reverse the procedure to install the oven control panel.
15. Test the oven to verify proper operation.
Figure 7: C Model Control Panel Removal
Pilot Safety Valve and Temperature Control Assembly (S Model)
WARNING: Always perform the Electrical Lockout/Tagout procedure before removing
any sheet metal panels or attempting to service this equipment. Failure to comply with
this procedure can cause property damage, injury or death.
WARNING: Perform the GAS LOCKOUT/TAGOUT procedure before servicing the unit.
1. Perform the OVEN CONTROL PANEL removal procedure for the standard oven.
2. Disconnect the flex line(s) from the pilot safety valve
3. Disconnect the 3/8" union from the bottom of the pilot safety valve.
4. Disconnect the flex line from the top of the temperature control.
