A SERVICE OF

logo

4.14 Fan/CPU 4 Replacement Procedures
4.14.2 CPU
Removing the CPU
The following describes the procedure for removing the CPU. (See Figure 4-21 and 4-22.)
1. Remove the following screws securing the CPU hold plate in the reverse order of the
number (31) on the CPU hold plate and remove the CPU hold plate.
M2.0x4.0B BIND screw x3
2. Remove the heat sink on the CPU.
M2.0x4.0B BIND
M2.0x4.0B BIND
CPU hold plate
Heat sink
Figure 4-21 Removing the heat sink
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-37