A SERVICE OF

logo

4 Replacement Procedures 4.6 Optical Drive
4.6 Optical Drive
Removing the Optical Drive
To remove the optical drive, follow the steps below and refer to figures 4-6 and 4-7.
CAUTION: Do not apply excessive force to the top of an optical drive.
1. Remove the following screws securing the optical drive.
M2.5×4B FLAT HEAD screw ×2
2. Slide the optical drive outward to disconnect it from the connector PJ1820 on the
system board.
M2.5
×
4B FLAT HEAD
Optical drive
Figure 4-6 Removing the optical drive
4-16 Satellite M30-35 Maintenance Manual (960-455)