HVL-MT24AM_GB 2-889-493-01 (1)
25
Basics
7 When the macro flash controller is charged, press the
shutter button to take a photo.
e macro ash controller is charged when the ash-ready lamp on the
control panel of the macro ash controller and the indicator in the camera
viewnder are both on.
When the correct exposure has been obtained for the photo just taken, the
ash-ready lamp on the control panel blinks.
e photo will be under-exposed if taken before charging is complete.
e use of a tripod or remote cord is recommended to reduce camera shake.
A camera-to-subject distance of less than 0.5m, and a magnication ratio of
more than 0.15X (greater than 1:7), are recommended to get the best results
from the macro ash units.
Always turn o the macro ash controller if the twin ash unit is not connected.
If the twin ash unit is not attached, but the controller is on, the camera ash
sync will be in eect and the resulting ambient exposures will be incorrect.
e camera’s AF illuminator is blocked by the adaptor ring or twin ash unit and
cannot be used for focusing.
