1
Optional Accessories
2-bay charging module for bodypack
battery
AXT901
AXT902 2-bay charging module for
handheld battery
AXT902
Batteries
This charger is only for use with Shure lithium-ion rechargeable batteries, such as
the AXT910, AXT920, or AXT920SL.
AXT920 Handheld Battery
Charging Modules
Handheld Charging Module
Included Components
IEC AC Power Cable (1) 95A9128
IEC AC Extension Cable (1) 95A9129
Shielded 3-foot Ethernet Cable (1) C803
Shielded 8-inch Ethernet Jumper Cable (1) C8006
Hardware Kit (1) 90XN1371
Mounting Screws for Charger Modules (8) 30B13476
Mounting Instructions
This component is designed to fit into an audio rack.
WARNING: To prevent injury this apparatus must be securely attached
to the rack.
Features
• Touring-ready battery charging and storage solution with comprehensive status display
• Configurable bays for mixing and matching 8 bodypack and handheld transmitter batteries
• Fully networkable for monitoring of all charging status parameters in Wireless Workbench 6
• Storage mode for charging or discharging batteries to optimal storage voltage
• Tracks battery health using charging cycle count and percentage of original capacity as metrics
• Charges batteries to 50% capacity within 1 hour
• Simple 3-button interface control
AXT910 Bodypack Battery
AXT900 Rack Mount Charging Station
The AXT900 charges up to 8 Shure rechargeable batteries in a single, compact rackmount housing. Interchangeable charging modules accommodate any combination of
handheld and bodyback transmitter batteries. The front panel display provides easy metering of all battery parameters, including charge status, time to full, and battery tem-
perature. When connected to a network, parameters can be monitored remotely using Wireless Workbench
®
6 software.
Bodypack Charging Module
Handheld and bodypack charger modules may be installed interchangeably into the
charger.
Caution! Remove AC power and batteries when installing charger
modules.
• To remove a module, remove the four (4) mounting screws and pull.
• To install, slide the module into the housing (noting the orientation of the guide
rails) until it is flush with the housing.
• Replace the screws.
