50
USER SETTINGS
Resetting account
The copy count of a single account or of all accounts
can be reset to 0. If no account numbers have been
established, the error code "15E" will appear in the
display.
[Resetting all accounts]
Press the [1] key and then press the [START]
key ( ).
The copy counts of all accounts will be deleted.
[Resetting a single account]
1
Press the [0] key.
2
Select the account number to be reset with
the [Copy ratio display] key ( ) and then
press the [START] key ( ).
Copying when auditing mode is enabled
When auditing mode is enabled, "- - -" appears in the display.
1
Enter your 3-digit account number
with the numeric keys.
When you enter your account number, "0"
appears in the display to indicate that copying is
possible.
2
Follow the appropriate steps to make
the copy.
3
When finished, press the [AUDIT
CLEAR] key.
To reset another account, enter the program
number for "Resetting account" (15) once
again in step 2 of "SELECTING AUDITING
MODE SETTINGS" (p.00), and repeat the
resetting procedure.
Note
If you enter an incorrect number, press the
[CLEAR] key ( ) and then enter the correct
number.
If you are performing an interrupt copy (p.00),
be sure to press the [INTERRUPT] key when
finished to exit interrupt mode.
Note
Note
If a misfeed occurs or the paper runs out
during copying, your session will not end even
if the [AUDIT CLEAR] key is pressed.
Note
