Sanyo PLC-WXU700 Manual

next previous

Maintenance and Cleaning

Thisprojectorusesahigh-pressurelampwhichmustbehandledcarefullyandproperly.

Improperhandlingmayresultinaccidents,injury,orcreateafirehazard.

●Lamplifemaydifferfromlamptolampandaccordingtotheenvironmentofuse.Thereisnoguarantee

ofthesamelifeforeachlamp.Somelampsmayfailorterminatetheirlifeinashorterperiodoftime

thanothersimilarlamps.

●Iftheprojectorindicatesthatthelampshouldbereplaced,i.e.,iftheLAMPREPLACEindicatorlights

up,replacethelampwithanewoneIMMEDIATELYaftertheprojectorhascooleddown.

  (FollowcarefullytheinstructionsintheLampReplacementsectionofthismanual.)Continuoususeof

thelampwiththeLAMPREPLACEindicatorlightedmayincreasetheriskoflampexplosion.

●ALampmayexplodeasaresultofvibration,shockordegradationasaresultofhoursofuseasits

lifetimedraws toanend. Riskofexplosionmay differ accordingto theenvironment orconditions in

whichtheprojectorandlamparebeingused.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’sAC plug from theAC outlet immediately. Contact an

authorized servicestationfor acheckup of theunit and replacementofthe lamp.Additionally, check

carefullytoensurethattherearenobrokenshardsorpiecesofglassaroundtheprojectororcomingout

fromthecoolingaircirculationholes.Anybrokenshardsfoundshouldbecleanedupcarefully.Noone

shouldcheck theinside ofthe projectorexcept thosewhoare authorizedtrained techniciansand who

arefamiliarwithprojectorservice.Inappropriateattemptstoservicetheunitbyanyone,especiallythose

whoarenotappropriatelytrainedtodoso,mayresultinanaccidentorinjurycausedbypiecesofbroken

glass.

LAMP HANDLING PRECAUTIONS

Resetting the Lamp Counter

BesuretoresettheLampcounterafterthelampisreplaced.WhentheLampcounterisreset,theLAMP

REPLACEindicatorstopslightingandtheLampreplacementicondisappears.

Note:

  Do not reset the Lamp counter without implementing

lamp replacement. Besure toresettheLampcounter

onlyafterreplacingthelamp.

Lamp counter Reset?

appears.

SelectYes,thenanother

confirmationboxappears.

SelectYesagaintoreset

theFiltercounter.

PresstheMENUbuttontodisplaytheOn-Screen

Menu.UsethePoint▲▼buttonstoselectSettingand

thenpressthePoint►ortheSELECTbutton.

UsethePoint▲▼buttonstoselectLamp counter

andthenpresstheSELECTbutton.UsethePoint▲▼

buttonstoselectLamp counter resetandthenpress

SELECTbutton.Lamp counter Reset? appears.

SelectYestocontinue.

Anotherconfirmationdialogboxappears,selectYesto

resettheFiltercounter.