19
0
15
22
1
/2
1
/2
30
45
51
WARNING:
The tool should never be connected to a power
supply when you are assembling parts, making ad-
justments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool
will prevent accidental starting that could cause
serious injury.
POSITIVE 0° BEVEL STOP
See Figure 21.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
90° cuts. However, misalignment can occur during shipping.
TO CHECK POSITIVE 0° BEVEL STOP
Follow these directions to check the positive 0° bevel stop.
■ Unplug the saw.
■ Place the saw in an upside down position on a workbench.
■ Move the lower blade guard out of the way so that the saw
blade is exposed.
■ Check the squareness of the saw blade to the base of the
saw using a carpenter’s square.
TO ADJUST POSITIVE 0° BEVEL STOP
Follow these directions to adjust the positive 0° bevel stop.
■ Unplug the saw.
■ Pull bevel adjustment lever upward to release.
■ Turn setscrew with hex key and adjust base until it is
square with the saw blade.
■ Securely lock the bevel adjustment lever.
WARNING:
Attempting a bevel cut without having the bevel
adjustment lever securely locked in place can result
in serious injury.
ADJUSTMENTS
Fig. 21
