Various Scan Settings
110
6
Scanning Custom Size Originals
This section explains the procedures for setting custom sizes and how to place
originals whose sizes do not match any template sizes.
There are two methods of setting custom size to scan originals:
• Scan the entire area of an original
• Scan part of an original
Scanning the Entire Area of a Custom Size Original
This section explains how to set a custom size to scan the entire area of an original.
You can use the following two methods to scan the entire area of an original:
• Enter the width of the original (X1) and then have the machine detect the
length automatically
• Enter the original size (X1 and Y1) and scan size (X3 and Y3)
To automatically detect the length of an original
Use the following procedure to scan the entire area of an original by specifying
only the width of the original. The length of the original is detected automatically.
Important
❒ You cannot enter a value of the length (Y).
This function is useful for scanning an original that is vertically long.
The following procedure is based on the example original shown below.
ATG024S
