[Auto E-mail Notification] tab
The settings on this tab are for sending a notification e-mail when the machine’s status changes.
You can specify up to two recipients.
•
[Display Name]
Enter a sender name for notification e-mail.
• [E-mail Address]
Enter the address of the recipient of the alert email.
• [Paper Misfeed]/[Out of Paper]/[Replace Print Cartridge Soon]/[Call Service]/[Replace
Print Cartridge]/[Cover Open]
Select which items to send notifications about.
[SNMP] tab
• [SNMP]
Select whether to enable the machine to use SNMP services.
• [Trap]
You can specify [Target Trap], [SNMP Management Host 1], and [SNMP Management Host
2].
• [Community]
You can specify [Get Community] and [Trap Community].
• [System]
Enter [Location] and [Contact] that are displayed on the top page.
[SMTP] tab
You can specify [Primary SMTP Server], [Port No.], [Authentication Method], [User Name],
[Password], [Device E-mail Address], and [Server Timeout (seconds)].
[POP3] tab
You can specify [POP3 Server], [User Account], [User Password], and [Authentication].
[Wireless] tab (Type 2 model only)
• [Wireless LAN Status]
The status of the following items is displayed:
[Wireless LAN Status], [Mac Address], [Communication Mode], [SSID], [Wireless Signal
Status], and [Wireless].
• [Channel]
Select an Ad Hoc channel only if Ad Hoc mode is selected for [Communication Mode].
• [Wireless Signal Status]
If Infrastructure mode is selected for [Communication Mode], displays the status of the signal
with the access point.
4. Configuring the Machine Using Utilities
52
