HD3000 User’s Guide
Professional Video Scaler and Color Management System
HD3000 User’s Guide 22
Initial Setup
During the initial setup, adjustment of the color and image quality should be performed.
After this initial setup is completed, the HD3000 will automatically store the settings for
optimal image viewing.
The HD3000 OSD is dependent upon the video source signal. It has been designed to
show a different OSD display with each input. Please refer to table A and B below for
more details on available adjustments for each signal.
With the exception of the VGA and BNC connections, if the HD3000 is not receiving a
signal from the input source device, the OSD will only allow the System Setup module to
be adjusted.
Table A
Composite S-Video RCA BNC
Video Decoder Video Decoder YPbPr YPbPr RGBs/RGB
Type
Auto, YPbPr, RGBs, RGB
Color Space
Auto, SDTV, HDTV Auto, SDTV, HDTV
Pedestal
0IRE, 7.5IRE 0IRE, 7.5IRE 0IRE, 7.5IRE 0IRE, 7.5IRE
Horizontal
-50~50 -50~50 -50~50
Vertical
-7~7 -7~7 -7~7
Frequency
-10~10 -10~10 -10~10
Phase
0~31 0~31 0~31
Table B
VGA HDMI
YPbPr RGBs/RGB
Type
Auto, YPbPr, RGBs, RGB
Color Space
Auto, SDTV, HDTV Auto, SDTV, HDTV
Pedestal
0IRE, 7.5IRE DVI-PC, DVI-Video
Horizontal
-50~50 -50~50
Vertical
-7~7 -7~7
Frequency
-10~10 -10~10
Phase
0~31 0~31
*Grey color blanks stand for N/A.
Note: Please exercise caution when adjusting the “Horizontal” and “Vertical” as this may cause the loss
of your image if the values are set out of range. We recommend using this adjustment only if you cannot
receive the input signal.
•
•
•
