57
R-1
Group Item Settings
Set-Up (continued) Operator Panel Function
Full Operation
, Limited Operation
Print Registration
0
, 0.05 mm Left, 0.10 mm Left,
0.15 mm Left, 0.20 mm Left,
0.25 mm Left, 0.25 mm Right,
0.20 mm Right, 0.15 mm Right,
0.10 mm Right, 0.05 mm Right
Reset Inhibit
No
, Yes
Print Suppress Effective
Yes
, No
Auto LF
No
, Yes
Auto CR (appears only when IBM
Proprinter emulation is selected)
No
, Yes
SI Select Pitch, 10 cpi (appears only
when IBM Proprinter emulation is
selected)
17.1 CPI
, 15 CPI
SI Select Pitch, 12 cpi (appears only
when IBM Proprinter emulation is
selected)
20 CPI
, 12 CPI
Time Out Print
Valid
, Invalid
Auto Select
No
, Yes
Ribbon Selection (Optional color
ribbon must be installed in order to
print in colors other than black)
Black Ribbon
, Black, Yellow,
Magenta, Cyan, Violet, Orange,
Green
Printhead Gap Adjust
0
, -1, +1
Graphics Speed High,
Low
Parallel I/F I-Prime Buffer Print, Buffer Clear, Invalid
Pin 18
+5v
, Open
Auto Feed XT (appears only when
Epson LQ emulation is selected)
Invalid
, Valid
Serial I/F (appears only when
optional Serial Interface is installed)
Parity
Serial Data 7/8 Bits
None
, Odd, Even
8 Bits
, 7 Bits
Protocol
Ready/Busy
, X-On/X-Off
Diagnostic Test
No
, Yes
Baud Rate 19200 bps,
9600 bps
, 4800 bps,
2400 bps, 1200 bps, 600 bps, 300
bps
Busy Line
SSD
-, SSD+, DTR, RTS
DSR Signal
Valid
, Invalid
DTR Signal
Ready on Power Up
, Ready on
Select
Busy Time
200 ms
, 1 sec
CSF Bin 1 (appears only with
optional Cut Sheet Feeder installed)
Line Spacing
6 LPI
, 8 LPI
Bottom Margin
Valid
, Invalid
Page Width (Model 591 only)
13.6”
, 8.5”
Page Length
11”
, 11-2/3”, 12”, 14”, 17”, 3”,
3.5”, 4”, 5.5”, 6”, 7”, 8”, 8.5”
Gap Control
Auto Gap
, Semi Auto Gap, 1, 2, 3,
4, 5, 6, 7, 8, 9
