A SERVICE OF

logo

Installation
Ultra Wide SCSI Mode
25
3 Turn on the power to the CR8e. After the power-on self-test has completed,
Status and Channel Mode LEDs will be solid green.
4 Access the Options menu on the Operator Control Panel and choose the
SAFTE CHAIN ID selection. Choose the “None” selection, refer to “SAFTE
CHAIN ID” on page 50.
5 After setting the cabinet identifications you must power cycle the subsystem.
Observe normal power cycling precautions by waiting a minimum of five (5)
seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID
conflict under normal conditions.
6 Power up your computer system and run the configuration program.
This completes the hardware installation.
NOTE: For additional configuration options using Ultra Wide SCSI, refer to the
nStor Feature Card User’s Guide.