NCR RealScan 7882 Installation and Owner Guide
497-0419630 Release F 09/02
Operating the Scanner
The NCR RealScan 7882 is a fixed position device that is not handled or moved by the
operator during operation. It is maintained and serviced by trained service personnel
only. The operator has no access to any laser module components.
The RealScan 7882 does not have a power switch. However, you turn it on and off by
using the circuit breaker switch, located in the checkstand, that supplies power to the
unit. Be sure this switch is in the On position.
The Red Indicator is on when the RealScan 7882 is ready. When the scanner reads a bar
code, the Red Indicator turns off and the Green Indicator turns on. Nothing happens if
the bar code is not read. The correct way to do pass-by scanning is to just slide the item
past the scan window without lifting the item. With presentation scanning, you lift the
item, move it straight toward the scan window, then bring the item back away from
the scanner.
Horizontal Mount In Counter
Red/Green Status Indicator
