NCR RealScan 7882 Installation and Owner Guide
09/02 497-0419630 Release F
Programming Defaults
Scanning the Default programming tag sets most program parameters to factory
defined values as shown in the following chart. However, some parameters do not
have default values so they are not changed, they stay as they are programmed.
01 Communications Protocol
Protocol No default value – remains as programmed
11 Good Read Tone
Tone On/Off On
Tone Frequency Choice 6 of 8 Levels
Tone Length Choice 3 of 16 Levels
Tone Volume Choice 4 of 8 Levels
Not-On-File Volume Choice 2 of 8 Levels
12 Timers
Lockout Time 750 Milliseconds
Restart Lockout Timer Off
Active Time 15 Minutes
13 Bar Codes – 1
UPC/EAN Enable
Version D Disable
Extend UPC-A To EAN-13 Disable
Extend UPC-E To UPC-A Disable
Periodical Codes Disable
Periodical Code Extension 2-Digit & 5-Digit
Send Data Data As Decoded
14 Bar Codes – 2
Code 39 Disable
Minimum Characters Allowed 8
Full ASCII Disable
Check Digit Present Disable
Transmit Check Digit Disable
Allow 1- or 2-Character Tags Disable
15 Bar Codes – 3
Interleaved 2 of 5 Disable
Bar Code Length Range Check
Value 1 08
Value 2 16
Check Digit Present Disable
Transmit Check Digit Disable
17 Bar Codes – 4
Code 128 Disable
Minimum Data Characters 3
UCC 128 Disable
