18
KEYPAD FUNCTIONS
9. Reset System Trouble? System troubles display and sound at the keypad.
Correcting the trouble will clear most indications, however the following error
codes will require manual reset: E11; E13; E19; E20 and E22. (See SYSTEM
TROUBLE ERROR CODES for a description of error codes.)
10. For installer's use only. If accidentally enabled, press the C button to exit.
11. Start Exit Time? (Start Exit Time programmed? YES NO.)
In Commercial Burglary systems, exit delay may have been programmed to start
after a central-station “ringback” (verification) signal has been received. If the
ringback tone has not been received within about 30 seconds after arming, a
communication problem may exist. Use this function to start exit delay manually,
then exit the premises immediately. Be sure to have your alarm specialist check
communications with the central station as soon as possible.
12. Activate Fault Find? For installer's use only. If accidentally enabled, press the
C button to exit.
13. Activate Locate? For installer's use only. If accidentally enabled, press the
C button to exit.
INTERIOR
BYPASSFIRE/TBL
09
INTERIOR
BYPASSFIRE/TBL
10
INTERIOR
BYPASSFIRE/TBL
11
INTERIOR
BYPASSFIRE/TBL
12
INTERIOR
BYPASSFIRE/TBL
13
GEM-RP3DGTL.pub
page 18
Wednesday, August 18, 1999 14:03
