55
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
USB Resume
This unit stores the point at which playback of a file was stopped previously,
and starts playback from the same point the next time playback is started.
On (Default) : Resume playback is set.
Remote : Resume playback is not set.
NOTE
•Resume playback works even if the USB memory device is disconnected and
then reconnected. However, if a dierent USB memory device is connected, the
resume information for the previous USB memory device is deleted.
•The resume information may be deleted when the USB memory device is removed
and files are added or deleted.
Digital Out
Switches the digital audio output on/o.
On (Default) : Use the digital audio output connector.
O : Do not use the digital audio output connector.
%
•When digital output is turned o, the “DOFF” indicator lights up on the display.
•The “Digital Out” has a memory retention function where the settings remain
stored and unchanged even when the disc is changed or the power is turned o.
Audio Out
You can set whether to fix (Fixed) or vary (Variable) the analog audio
output level.
Fixed (Default) : Fixes the analog audio output level (0 dB).
Variable : You can adjust the analog audio output level using the VOLUME
df buttons on the remote control.
%
•When you enter “Fixed” or “Variable”, “Are You Sure?” is displayed for
approximately 3 seconds on the display. Select “OK” to set or “Cancel” to cancel
the selection.
•The remote control needs to be set in order to adjust the analog audio output level
(vpage57).
•When the analog output level is adjusted, the headphone volume also changes.
When using the headphones, adjust the volume to a suitable level by also using the
headphone volume control knob.
•When “Variable” is selected, the analog audio output level can be adjusted to --- dB
(minimum) and between the range from –99 dB – 0 dB (Default：–40 dB).
NOTE
•Note that the analog audio output level changes to the maximum (0 dB) when the
analog audio output setting is changed from (Variable) to (Fixed).
•Before changing the settings, turn the volume of the amp connected to the analog
audio output terminals (AUDIO OUT) and headphones connected to the unit to the
minimum volume.
