5
Connections Playback Settings Tips Appendix
ENGLISH
Preparation
q SIGNAL GND (ground) terminal
Used to connect the earth wire of a turntable.
NOTE
This terminal is not a safety ground.
w Audio input connectors (AUDIO IN)
Used to connect devices equipped with analog audio
connectors (vpage8).
e Input/output connectors (Recordings)
(RECORDER-1, RECORDER-2)
Used to connect to a recording device (vpage9).
r Speaker system terminals
(SPEAKER SYSTEMS)
Used to connect speakers (vpage7).
t REMOTE CONTROL connectors
Used to connect to a Marantz audio device that is compatible
with the remote control function (vpage15).
Rear panel
Q0 o
q t y u iw e r
y AMPLIFIER MODE switch
Used to switch the amplifier mode (STEREO/BI-AMP)
(vpage11, 12).
u F.C.B.S. connectors
Used to connect a high quality playback system using two
or more of these units (vpage10).
i AC inlet (AC IN)
Used to connect the power cord (vpage15).
o Power amplifier direct connectors
(POWER AMP DIRECT IN)
Used to connect a pre-amplifier when this unit is used as a
power amplifier (vpage14).
Q0 PRE OUT connectors
Use this to add such equipment as a power amplifier or
subwoofer (vpage14).
Part names and functions
1.PM14S1U_ENG_0722.indd 5 2013/07/25 17:08:23
