25
Preparation Connections Playback Settings Tips
ENGLISH
Appendix
• RMS Power output:
(20 Hz – 20 kHz 2-channel simultaneously
driven)
90 W × 2 (8 Ω/ohms)
140 W × 2 (4 Ω/ohms)
• Total harmonic distortion:
(20 Hz – 20 kHz 2-channel simultaneously
driven, 8 Ω/ohms)
0.05 %
• Output band width: (8 Ω/ohms, 0.05 %) 5 Hz − 40 kHz
• Frequency response: (CD, 1 W, 8 Ω/ohms
load)
5 Hz − 100 kHz ± 3 dB
• Damping factor: (8 Ω/ohms, 20 Hz − 20 kHz) 100
• Input sensitivity/Input impedance
PHONO (MC): 270 µV / 100 Ω/ohms
PHONO (MM): 2.7 mV / 47 kΩ/kohms
CD/LINE: 240 mV / 20 kΩ/kohms
P. DIRECT IN: 1.7 V / 20 kΩ/kohms
• Output voltage/Output impedance
PRE OUT: 1.7 V / 220 Ω/ohms
• Maximum allowable PHONO input level
(1 kHz)
MC: 15 mV
MM: 150 mV
• RIAA deviation: (20 Hz−20 kHz) ± 0.5 dB
• S/N (IHF-A, 8 Ω/ohms)
PHONO (MC): 75 dB (0.5 mV Input, 1 W Output)
PHONO (MM): 86 dB (5 mV Input, 1 W Output)
CD/LINE: 106 dB (2 V Input, Rated output)
• Tone control
BASS (50 Hz): ± 10 dB
TREBLE (20 kHz): ± 10 dB
• Power requirement: AC 120 V, 60 Hz
• Power consumption (UL60065): 220 W
• Standby power consumption: 0.2 W
For the purpose of improvement, the specifications and design are subject to change without
notice.
Specifications
v A
Accessories ··························································1
Adjusting the tone ··············································17
Adjusting the volume ·········································16
Auto Standby mode ···········································19
v C
Cables used for connections ································7
Connection
5.1 multi-channel playback ······························· 12
F.C.B.S. ····························································· 10
Player ································································· 8
Power-amplifier ················································ 14
Power cord ·······················································15
Pre-amplifier ····················································· 14
Recorder ····························································9
Remote control connectors ····························· 15
Speaker ······························································8
Stereo complete bi-amp ···································11
v F
Front panel ···························································4
v M
MM/MC cartridge select ···································· 24
v P
Protection circuit ················································24
v R
Rear panel ····························································5
Remote control unit ·············································6
Inserting the batteries········································2
v S
Selecting the input source ·································16
Speaker impedance ············································24
v T
Tips ·····································································20
Troubleshooting ·················································20
Turning off the sound temporarily ······················17
Turning the power on ·········································16
Index
1.PM14S1U_ENG_0722.indd 25 2013/07/25 17:08:36
