88
Various memory functions
Personal memory plus function
This function sets the settings (input mode, sound mode, HDMI
output mode, MultEQ
®
, Dynamic EQ, audio delay etc.) last selected
for the individual input sources.
The surround parameters, tone control settings and the volumes of
the dierent speakers are stored for the individual sound modes.
Last function memory
This function stores the settings which were made before going into
the standby mode.
When the power is turned back on, the settings are restored.
Remote lock function
•When not connecting an IR receiver, disable the Remote lock
function. When the function is enabled, you can not perform
operations with the remote control unit.
•By default, this function is disabled.
X ON/STANDBY
STATUS
DISPLAYM-DAX
PRESET CH
PRESET CH
n Disabling the sensor function of the remote
control unit
1
When the main unit is in standby mode, press X
while holding down M-DAX and DISPLAY on the
main unit.
2
Press PRESET CH – or PRESET CH + to select “RC
LOCK On”.
3
Press STATUS to enter the setting.
The infrared light receiving function is disabled.
n Enabling the remote sensor function
1
When the main unit is in standby mode, press X
while holding down M-DAX and DISPLAY on the
main unit.
2
Press PRESET CH – or PRESET CH + to select “RC
LOCK zO”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
The infrared light receiving function on the main unit is enabled.
