15
Setting the network [Network]
•For details on “Quick Setup” operations, see the separate
“Getting Started”.
•If you cancelled “Quick Setup” menu or changed the
network environment, perform “Menu” – “Quick Setup”.
Connecting wired LAN
Use this procedure to configure the wired LAN settings.
n Network connecting
(when “DHCP”settings are “On”)
When using this unit with the broadband router’s DHCP
function enabled, this unit automatically performs the IP
address setting and other settings.
1
Connect the LAN cable
(vpage 8 “Connecting to a
home network (LAN)” – “Wired
LAN”).
2
Press X (on/standby) to turn on
power to the main unit.
3
Press MENU.
Turns on the Menu settings mode
and the Menu appears on the
display (vpage 11 “Menu
map”).
4
Use ui and ENTER to select “Network” –
“Settings” – “DHCP (On)”, then press ENTER or p.
“Select DHCP” menu appears.
5
Use ui to select “On”, then press ENTER or p.
“Setup Ethernet” menu appears.
6
Use ui to select “Test Connection”, then press
ENTER or p.
“Wait for the network to connect...” is displayed, and
the unit starts connecting to the LAN.
•When the connection is made successfully, “Connected!”
appears.
•If the connection cannot be established, “Connection
Failed” is displayed. Perform steps 1 – 6 again.
You may need to set the network connection manually,
depending on the provider you use. To set the connection
manually, use the setting procedure of “Network connecting
(when “DHCP” settings are “O”)”.
n Network connecting
(when “DHCP” settings is “O”)
This section explains the settings when connecting this unit
to a network that does not have a DHCP function.
To configure the settings manually, check the setting details
with your network administrator.
1
Perform steps 1 – 4 of the
“Network connecting (when
“DHCP” settings are “On”)”
procedure and select “O” in
step 5.
“Setup Ethernet” menu appears.
2
Use ui to select “IP Address”,
then press ENTER or p.
“Enter IP Address” menu appears.
3
Use uip or 0 – 9 to input the
IP address and press ENTER.
4
Use uip or 0 – 9 to input the address for
“Subnet Mask”, “Gateway”, “Primary DNS”, and
“Secondary DNS”.
5
Use ui to select “Test Connection”, then press
ENTER or p.
“Wait for the network to connect...” is displayed, and
the unit starts connecting to the LAN.
•When the connection is made successfully, “Connected!”
appears.
•If the connection cannot be established, “Connection
Failed” is displayed. Perform steps 1 – 5 again.
