Installation
Installation
Assemble the Power Supply
Assemble the AC adapter for the MX7 Battery Multi-charger before connecting it to the charger.
The AC power supply for the multi-charger is shipped with the multi-charger. Contact your LXE representative if there is no AC
cable.
The multi-charger powersupply is intended for use with the multi-charger only.
l Plug the3-prongcable into an AC wall outlet.
l Firmly press the female end of thepower cable into the male connector on the AC power adapter. An LED on the power
adapterilluminates when AC poweris available.
l AC poweris now being applied to the poweradapter.
Setup
Prerequisite: The AC Adapter is assembled andreceiving AC power.
The battery chargershould be located in an area whereit:
l Is well ventilated.
l Is not in hightraffic areas.
l Locates or orients the AC cordso that it will not be stepped on, tripped overor subjectedto damageor stress.
l Has enough clearance to allow easy access to the power port on theback of the device.
l Is protected from rain, dust, direct sunlight or inclement weather.
This device is intended for indooruse only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
Place themulti-charger on a flat, horizontal, hard surface or fasten securely to astable surface using the keyhole openings on
the bottom of the multi-charger.
Do not insert battery packs until the chargerhas finished poweringup:
l Insert the power connector into the power outlet at the back of the charger.
l AC poweris now being applied to the charger and it begins to power up.
l Charge bay LEDs flash while thechargerenters andexits the startup check.
l When the charge bay LEDs are not illuminated, thebattery chargeris ready for use.
E-EQ-MX7CHGROG-E-ARC [ 4 ] MX7 Battery Multi-Charger/AnalyzerUser Guide
