Fig. 18
u
Attach the unit door to the adjusting bolts
Fig. 18 (13)
and
loosely screw the locknuts
Fig. 18 (10)
onto them.
u
Close the door.
u
Check the gap between the door and the surrounding unit
doors.
u
To laterally align the door: push unit door in X direction.
u
Align the door vertically Y and in the lateral inclination:
adjust adjusting bolts
Fig. 18 (13)
with a screwdriver.
w
The unit door is flush and in alignment with the surrounding
unit fronts.
u
Tighten locknuts
Fig. 18 (10)
.
Fig. 19
u
Drill pilot holes in the door of the unit (possibly make prelimi-
nary hole with a bradawl).
u
Screw the appliance door to the unit door with screws
Fig. 19 (19)
passed through the mounting brackets
Fig. 19 (22)
.
Fig. 20
u
Adjust the depth of the unit door (Z): Undo the screws
Fig. 20 (15)
at the top and screws
Fig. 21 (24)
at the bottom,
then move the door.
u
Do not allow knobs and sealing lips
to make contact - important for func-
tion!
u
Allow an air gap of approx. 2 mm
between the unit door and the body
of the unit.
Fig. 21
u
Check the fit of the door and readjust if necessary.
u
Tighten all screws.
u
Tighten the locknuts
Fig. 21 (10)
with the ring spanner
Fig. 21 (21)
, while holding the adjusting bolts
Fig. 21 (13)
with a screwdriver.
u
Attach top
cover
Fig. 22 (26)
and
snap into place.
Fig. 22
Putting into operation
7
