A SERVICE OF

logo

Open as PDF
next previous
Assembly Instructions
5.
Step 7
Remove the socket head stop bolt from the table frame. See
figures 5 below.
Step 8
Slide the clamping arm onto both the top and bottom frames so
that it rolls freely. See figures 6 below.
Remove socket head bolt.
Step 10
Connect to your shop’s air supply at 3/8” fitting located on top of
clamping arm. See figure 8 above.
Step 11
Air pressure regulator on top of clamping arm controls pressure to
optional screw gun. See figure 9 above.
Step 9
Replace stop bolt, tighten and reattach the plastic cap in position.
Replace socket head bolt and end cap.
If you have additional questions on the set-up, operation or
maintenance of your clamping table please call 800-447-8638
or email us at techsupport@kregtool.com.
4-
4-
Figure 5
Figure 8
Figure 7
Figure 6
Figure 9