Operating Instructions - Optional Screw Gun & Hose
9.
Optional Screw Gun
This table can accommodate an optional pneumatic screw gun
for use in assembling frames (Kreg part number CT6030). An air
regulator on the top of the transfer arm regulates the amount
of air that is supplied to the screw gun. We recommend that you
adjust the pressure to a level that causes the screw gun to stall out
when the screw has been seated completely. To adjust, simply turn
the regulator and run the gun to reach the desired setting. We find
that a setting around 60 psi works well for driving screws into oak
with the CT6030 screwgun.
4-
Optional Polyurethane Coil Hose
This polyurethane coil hose (Kreg part number CT6023) is a great
complement to our Screw Gun. It is 8’ long, plenty of length to reach
across the table and has brass 1/4” NPT fittings on both ends.
Regulator controls amount of air pressure to the screw gun.
Fitting where screw gun is connected to the table.
Screw Gun
Item# CT6030
Coil Hose
Item# CT6023
