E26
Synchronizing flash and external trigger
Trigger
VD
(Internal)
EXP
(CCD accumulation period)
FLASH
Analog
output
WEN
To synchronize the flash with the input of an external trigger, use the [REMOTE] connector on
the rear.
Pin configurations of connectors ( ੬ page E12).
Ⅲ When the shutter mode is other than “RANDOM” “EEI” ( ੬ page E34, SHUTTER item)
● In response to the trigger input, the KY-F1030 outputs a flash signal for the CCD accumulation
period of the next frame.
● The image shot at the moment that the FLASH signal is outputted is output as the next frame.
● In the case of digital output, output stops with shooting of this frame and the image on the PC’s
monitor will be in the FREEZE condition.
● How to cancel the FREEZE condition can be selected. ( ੬ page E40, [FRZ CANCEL] item)
● The trigger interval must be minimum 3 frames (405 msec) at a shutter speed of 1/7.5 s or
faster.
● When the FREEZE cancel mode is set to “MANUAL”, FLASH will not be output in response to
the trigger input for FREEZE cancellation.
Timing chart
4. Shooting a computer monitor screen (cont’d)
MEMO
• During output of the FLASH signal, the [FREEZE] indication will appear momentarily on the com-
puter monitor. If it is preferred that the indication is not shown, set the [FRZ DISPLAY] item to “OFF”.
੬ Page E40, [FRZ DISPLAY] item.
