Other Hints on
Caring for Your Oven
Cleaning Otlner Surfaces of Your Oven
Door and control panel drinn: The metal trim around the door and the control
panel can be cleaned with any nonabrasive cleanser such as Bon-Ami or soapy water;
rinse well. Be careful not to use an excessive amount of water.
Glass on fine coudrol i):uncl front ;und oven door front: To clean,useany
suitableglasscleanerorsoapy water.To preventmoisturefrom gettingbehindtheglass
controlpanel,spraya clothwithglasscleanerthenwipe thepanel.
Control I_nobs:
The knobs on the control panel can be removed with the controls in the OFF position.
Pull each knob straight from the shaft. Clean knobs with a hot sudsy cloth then dry. To
replace each knob, match flat part of knob opening, returning in OFF position.
Ovefn Light IBulb
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven cavity including the light bulb is cool before
attempting to remove.
1'o f't_ll,lacc light I.ull.:
1. Carefully remove the glass light lens, lens retainer,
and heat resistant gasket by removing the four
screws in the light lens retainer using a phillips
screwdriver. Note: The light lens is separate from
the light lens retainer. The three pieces will drop
down into your hands at the same time.
2. To obtain firm grasp on bulb, wear protective
rubber gloves. Remove by turning bulb to the left.
Do not touch a hot oven light bulb with a damp
cloth as bulb will break. Note: If the bulb does
break and you wish to remove it, be certain power
supply isdisconnected and wear protective gloves.
You may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance
bulb. Bulb with brass base is recommended to
prevent fusing of bulb into socket.
4. Place light lens inside of light lens retainer. Hold-
ing the light lens, lens retainer, and heat resistant
gasket in place, insert the fourscrews into the light
lens retainer and tighten.
22
