DIMENSIONS AND SPECIFICATIONS
Height 13"
Width 12-1/2"
Length 18"
Weight 42 lbs.
Power Supply 120V
Horsepower 1-1/2 HP
Beveler Nominal Amperage 14A / 120V
Maximum Current Load 18A / 120V
Start-up Current 11A / 120V
Revolutions per Minute 3450 RPM
Cutting Speed 1800 SFPM
Angle Range 30º to 60º
Bevel Width (Maximum) 3/4"
9
NOTE
:
BEVELER REQUIRES
12
INSERTS
.
REGULAR MAINTENANCE
CAUTION!
NEVER ATTEMPT TO MAKE ANY ADJUSTMENTS OR REPAIRS BEFORE DISCONNECTING THE BEVELER FROM POWER SOURCE.
1. Inspect and replace worn screws, adjusting tools, insert rings and other parts.
2. Inspect control panel, switches and power cord to insure proper electrical operation.
3. Clean BM-20 occasionally with clean rag and mild cleaning solvent to maintain appearance and operation.
BEVELING PIPES
Roller attachment (part #309 to #319) allows you to bevel pipes and curves with the BM-20.
1. To prepare the machine for work on pipes, remove part #307. Slide it off the machine and replace it with the pipe
attachment (part #309 to #315).
2. Move the housing (part #205) to the “zero width of cut” position (refer to the section in the manual entitled,
“Adjusting Bevel Angle”).
3. Place machine on the edge of pipe in such a way that the milling tool touches the workpiece, and then fasten both
rollers. You can now adjust machine to the desired beveled angle. note: Do not use the BM-20 on pipes under
6-1/4" in diameter.
