User's Manual U13502EJ2V0UM00
37
CHAPTER 4 BASIC OPERATING PROCEDURE
This chapter explains the basic operating procedure, using as an example the
µ
PD78F4216 used as the target.
Specifically, this chapter discusses how to start the system and how to write a program to the target by executing the
E.P.V. command. For the other commands and their usage, see
Chapter 5
.
[Operating conditions in this example]
The operating conditions for the example used in this chapter are as follows:
HOST I/F : PRINTER I/F
Target :
µ
PD78F4216 (with FA adapter)
Interface : UART 9600 bps
Clock In Flashpro 16 MHz
Mode CHIP
V
DD
5.0 V
V
PP
10.0 V
Command : E.P.V.
(1) Starting the system
•
Connect the PG-FP3 and host.
Confirm that the interface select switch is set to the printer interface position.
•
Connect the PG-FP3 and target (FA adapter).
Confirm that the target V
DD
switch is set to the OUT position.
Photo 4-1. Connection of Host, PG-FP3, and Target
