114
114 | Maintaining and Transporting the Printer
•
To enable printable pages, press the button until you see PAPER
COUNTER
, then press the Menu button. Press the button to
select an option, then press the
Menu button. Press the
button when done.
• To change the units of measurement, press the button until you
see
UNIT, then press the Menu button. Press the button to
switch from
METER to FEET/INCH, then press Menu to select
the units you want. Press the button when done.
• To change the default cutting pressure, press the button until you
see
CUT PRESSURE, then press the Menu button to display
100%. Press the button to decrease the pressure, or the button
to increase it (in 1% increments). Press
Menu to select the
setting you want. Press the button when done.
• To run a super strong cleaning cycle, press the button until you
see
SSCL, then press the Menu button to display EXEC. Press
Menu to start the cleaning cycle.
• To enable or disable roll paper feeding at power-on, press the
button until you see
ROLL PPR FEED, then press the Menu
button. Press the button until you see the setting you want, then
press the
Menu button to select it.
• To return all control panel settings to their default values, press the
the button until you see
DEFAULT PANEL, then press the Menu
button to display EXEC. Press Menu again to restore the
default settings.
• To check the ink cartridges, press the button until you see CRTG
INFO MENU
, then press Menu . Press the button to select
each cartridge, then press
Menu to view the information.
3. To exit the maintenance mode, turn off the printer by pressing the
P power button. Press the P power button again to turn on the printer
in the normal operating mode.
