Step3
IMPORTANT:Ifyouhavenotalreadydone
so,youmustdisconnectthenegative(-)termi-
nalofthebatterybeforecompletingthenext
steps.
• Repeat with the remaining dash adapter
nut (F) until seated on bottom surface of
the nut already installed. Use care to
ONLY tighten second nut. Tighten using
moderate force, Do not over tighten,
• The assembly is now secure to the dash of
the tractor.
NOTE: If a hole was drilled in a dash not
equipped with mounting locations, (Step Ib)
you will need to slide the dash adapter spacer
(I) over hoses of the misting arm assembly (BB)
prior to proceeding.
Slide one dash adapter nut (F) over supply
lines and thread onto adapter until seated
on the bottom surface of dash. Tighten
using moderate force. Do not over
tighten.
