4-5
Site Survey Guide for Deploying Cisco 7920 IP Phones
OL-6315-01
Chapter 4 Conducting a WIPT Survey
How To Survey for the WIPT
Manual Survey for the WIPT
You can use passive or active mode when you use ACU to run a site survey. Figure 4-3 shows the ACU
Site Survey windows.
Figure 4-3 ACU Site Survey Windows
To set up active mode, click the Setup button at the bottom of the screen. If the Setup button is
unavailable, the client is using a version of firmware that does not support active mode, and you should
upgrade the firmware. The destination MAC address should belong to the access point to which you want
to test coverage. The destination MAC address prevents the client from roaming to another AP. For most
surveys, you should uncheck the Destination is Another Cisco Device check box. Set the packet size
to 256. Set the Data Rate to 11 Mbps. On the access point, set the 11 Mbps data rate to required, and
set all other data rates to disabled.
