Operating Instructions
Applying changes to Functions (Quick Instructions)
Unless otherwise stated changes in the control board can be applied in the
follow
ing manner.
1. Press any of the [MENU]
arrow buttons repeatedly until the display reads
the menu function you wish to change.
2. Press any one of the [SELECT] a
rrow buttons to activate menu function.
The display will show the current state of the function, either “Off” or “On”
with exception for DMX addressing and Lamp Time.
3. Press any one of the [SELECT] a
rrow buttons again to change the
currently selected setting.
Operating Mode
• DMX control mode will provide the greatest flexibility
and creativity. Each fixture trait can be
controlled individually using any universal DMX-512 controller.
DMX Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to
customizing or creating a show. You can tailor your programming to suit a specific event. Whether it
is a wedding where a spot light may be required or a lead singer requiring a color solo, the
opportunities are endless. In this mode you will be able to control each individual trait of the fixture
independently.
Daisy Chain Connection
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first f
ixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Menu Functions
DMX-512 addressing
DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start
address" from 1 to 511. A fixture requiring one or more channels for control begins to read the data
on the channel indicated by the start address. For example, a fixture that occupies or uses 6 channels
of DMX and was addressed to start on DMX channel 100, would read data from channels: 100, 101,
102, 103, 104, and 105. Choose start addresses so that the channels used do not overlap and notate
the start address selected for future reference.
Daisy Chain Connection
LEG-6000 User Manual 10 Revision: 2007-03-06/09:06
