![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/8/67/8675bc7a-80c4-47ca-a7b8-fdc77ca33c8f/8675bc7a-80c4-47ca-a7b8-fdc77ca33c8f-bg55.png)
Sending Methods
2-13
2
Basic Send and Receive Methods
Details of each item are shown below.
NOTE
•
You can change settings for Resolution, Density, and Image Quality before you
start sending. (See "Resolution, Density, and Image Quality," on p. 2-2).
•
To cancel Manual Sending, press [End].
5
When you hear the other party or carrier signal (a high-pitched
tone), press (Start).
Scanning starts and the document is sent.
During the transmission, the transaction number, destination's telephone number,
and page number are displayed in the Job Monitor area.
[RX Start]: This key is used only for receiving data from a fax
information service. It is not used when sending. (See
"Fax Information Services," on p. 3-41.)
[Tone]: Press when you want to directly call an extension line
that is connected to a PBX (Private Branch Exchange),
which accepts only tone signals. If you press [Tone], the
letter <T> appears. (See "Fax Information Services," on
p. 3-41.)
< > or < >:
Press [▼] (reduce) or [▲] (increase) to adjust the
volume of the dial tone.
[One-touch Dialing]: Press to specify destinations using the one-touch
buttons. (See "Address Book," on p. 2-19.)