46
If you connect additional video
equipment to your television, you
must register the equipment in the
CONNECTIONS menu.
When the system is first set up, the
equipment connected at that
particular moment is detected by the
television, and the CONNECTIONS
menu appears automatically on the
screen. If you connect equipment at
a later date, on a permanent basis,
then you must register this
equipment in the CONNECTIONS
menu.
For information about where and
how to connect extra equipment,
refer to the previous pages and the
chapter ‘Socket panel’ on page 40.
Register additional video equipment
What is connected?
Registering the equipment connected to the
television enables you to activate it with the
Beo4 remote control.
> Press TV to switch on the television.
> Press MENU to bring up the TV SETUP menu
and press
to highlight OPTIONS.
> Press GO to bring up the OPTIONS menu.
CONNECTIONS is highlighted already.
> Press GO to call up the CONNECTIONS menu.
> Press
or to step between the different
sockets: AV1, AV2 and AV3.
> Press GO to be able to register a connected
product to the highlighted socket.
> Press
or to move between the types of
sockets.
> Press
or to register what you have
connected to the highlighted socket.
> Press GO to be able to select another AV socket.
> When you have completed your settings, press
STOP to back up through previous menus or
press EXIT to exit all menus directly. If, for some reason, you disconnect the extra
equipment and then disconnect the television from
the mains, you may have to register the equipment
again upon reconnection, even if you have not
changed your setup of extra equipment.
