Operation Instruction
13
the tool checked by a qualified technician. Any tool that cannot be
controlled with the power button is dangerous and must be
repaired.
2NOTE: Please check following methods to avoid injury.
FOR WALLS: For inspecting the inside walls, be sure to shut
off the circuit breaker to the whole house before using the tool.
FOR PIPES: If you suspect a metal pipe could contain an
electric charge, have a qualified electrician to check the pipe
before using.
2FOR AUTOMOBILES: Be sure the automobile is not running
during inspection. Metal and liquid under the hood may be hot.
Don’t get oil or gas on the imager head.
4.4 Tool and Work Area Set-Up
CAUTION: Set up the tool and work area according to these
procedures to reduce the risk of injury from electric shock,
entanglement, and other causes and prevent tool damage.
1) Check work area for:
Sufficient lighting.
Do not work in area until flammable sources have been
identified and corrected. The tool is not explosion proof and
can cause sparks.
Do not use the tool while standing in water.
2) Check the area and determine if MaxiVideo
TM
MV208 Digital
Inspection Videoscope is the correct tool for the job.
Check the access points to the area.
Check if there is any electric power supplied to the area to
be inspected.
Check if the any liquids will be occurred during the
inspection. The Image head and cable were waterproof to a
depth of 3m (10'), Greater depths may cause leakage into
the imager head and cable and cause electric shock or
damage the tool. The display unit is not waterproof and
should not be exposed to wet conditions.
