ASSEMBLY
USE PTFE tape for all threaded air connections
1. Assemble the intake manifold (#08). Attach the pressure gauge (#05) to the top of the
intake manifold (#08), and turn the gauge so that it can be seen across the top of the
tank. Next, attach the sand meter valve (#18) to the bottom of the manifold (#08). Attach
the connector (#07A) to the bottom of the sand meter valve (#18); attach the nipple
connectors (#07) to the manifold (#08). Attach the safety valve (#06) to the manifold
(#08) as shown in the diagram.
2. Assemble the water trap filter (#12). Two nipple connectors (#07) are screwed into each
side of the filter (#12). Attach the nipple connector (#07) to one side of air supply valve
(#14); then attach the male-female connector (#15) to the other side of air supply valve
(#14). When ready to operate the sandblaster, the air hose from compressor will fasten
to the male-female connector (#15).
3. Place the tank (#03) on a table with four clips up. Screw the water trap filter(#12) and its
parts into the hole at the side of the intake manifold. Then screw the open end of the
nipple connector (#07) with intake manifold (#08) and pressure gauge (#05) attached
into the threaded hole on the side of the filler pipe on top of the tank. Again, be sure that
the manifold and gauge are vertical.
4. Assemble the sand outlet valve into the hole at the bottom of the tank. Attach four parts
in order: 1pc Nipple Connector (#07); Sand Metering Valve (#18); the other nipple
connector (#07) and the sand outlet pipe(#19).
5. Assemble the sand meter valve. Slide two hose clamps (#26) over each end of the sand
hose (#25). Press one end of the hose over the nipple on the sand outlet pipe (#19) and
the other end over the intake connector(#27). Both hose ends should be firmly seated
on the nipples. Slide the hose clamps along the hose to each nipple and tighten the
clamps firmly. They have to resist the force of 65 to 125PSI.
6. Fasten the handlebars (#02) to the tank by using pan screw (#11), washer (#10) and
hex nut (#09). Fixing axle brackets (#20) on the tank by using screw (#16). NOTE: Keep
the handle curve ends upward.
7. Locate axle (#23) and slide it through the holes at the sides of the axle brackets (#20).
Place one wheel (#22) at each end of the axle and fasten them into place with cotter pin
(#24) and washer (#21).
8. Insert the fixed foot (#17) onto the fitting on the bottom of the tank near the edge. Use
the last cotter pin(#24) to hold the foot on the tank.
9. Before operating, go back over each connection, double checking to ensure that all
connections are tight and properly seated.
