00
Magazine
lay-on roller arm
6.3 Removing Exposed Film
If only part of the lm roll has been exposed and you intend
leaving a ‘short end‘ in the magazine, cut the lm loop
squarely through a perforation.
The following steps should be carried out in
total darkness in a darkroom or changing tent!
• Open the take-up side door by ipping the locking
grip upwards and turning the grip counter-clock-wise.
• Lift up the door and remove it by pulling it to the left.
• Manually wind the lm roll counter-clockwise until the
lm tail comes free from the lower sprocket roller.
• Swing the lay-on roller arm aphoto away from the
winding shaft until it locks in place.
• Pull the lm roll upwards and off.
Note: When pulling the lm roll off the shaft, grip the
roll rmly to prevent the middle of the lm roll
from sagging down.
The lm tail should never be pulled to tighten the
roll. This causes scratches and static discharging.
lower sprocket roller
